"
*"K"
-F'*
F***
)'*
How do I store models on my Campac? How do I move models from my Campac
back into my transmitter?
&)"<*
133"53C3C5?5C&>7
B)<1
1. With the transmitter off, install the Campac.
2. Initialize the Campac if new.
3. Select the model you intend to copy to the Campac.
4. Use the copy model function to copy from the existing memory into an open
memory in your Campac.
8)<"1
1. With the Campac in the transmitter turn the transmitter on.
2. Select the model that is in the Campac that you wish to copy.
3. Use the copy model function to copy from the Campac back into the transmitter.
>)<*133"5
3C3C5?5C&>N
I want to use the 9Z's FMC functions to set up fuel mixture on my giant scale race
plane so I can adjust the high speed mixture on the left slider. Also, I want the
throttle cut to dump the fuel mixture servo to wide open which releases all pressure
in the tank and bring my engine up to 1/2 throttle to burn off all fuel immediately.
Can it do that?
"00.<@
'
To Next Page
Loading...
