Model # = #10 (has preset
curve)
FMC servo = ch 8 Throttle = ch 8
Activate fuel mixture.
From Model Menu select
FMC and activate.
P D F F N R
From Condition Menu
select FMC.
O D L
Option: change to
UNMIXED. This will cause
the mixture servo to move
based on throttle stick
position regardless of
curves, mixes, etc.
A G (not needed in this
example)
Adjust curve as needed.
R to change point.
B then E-M to set point.
Option: Go to Rate setting
and adjust amount of effect
the channel 8 control (right
slider default) has over the
mixture at high speed (51-
100%) or low speed (0-
49%).
O C. 51%+ means channel
8 control affects the mixture
above 1/2 throttle. The
farther from 50% the larger
the effect. Set to 100% for
now for maximum
adjustability.
Option: adjust acceleration
and deceleration settings
(higher settings means
mixture overcompensation
is more pronounced. 0 =
no
acceleration/deceleration.
Q (F-M) Ex: 0%.
P (F-M) Ex: 0%.
Set up fuel mixture.
Close. N R
Change where channel 8 is
controlled to left slider.
Open FUNC in Model
menu and change Ch 8
assignment. Close.
P B K O L P E N R
Open CUT in Model menu
and activate.
P C F A F
Set up throttle cut function.
Set throttle % to -100 to
move throttle as far as
possible TOWARD 1/2
stick (opposite of normal
throttle cut setup per
customer's request.)
C E M
To Next Page
Loading...
