Set mixture rate to +100%
to move mixture as far
open as possible (to dump
pressure per customer's
request.)
D M
Assign to momentary on
switch. (ex: F) Close.
F P N N R
Throttle movement is still not enough to burn off left over fuel quickly.
From condition menu open
PMIX.
O B I
Select Mix 1 and make it
active.
F A F
Make it an offset mix. D F
Set slave channel as
throttle.
C G
Assign to cut switch F. P F P N
Set desired amount of
travel. (Test and adjust
travel as needed.)
O E M
Use a pmix to offset
throttle closer to half stick.
Close. N N N R
What is a PLL error?
)9--*''
?'''
-(ED..ED)-""
**"
I did not find the answer to my question here. How do I get further assistance?
• Ask a technical support, customer service, or product related question
http://www.futaba-rc.com/techsupport/index.html
• Submit a product suggestion or improvement idea http://www.futaba-
rc.com/suggestion.html
• Contact the Futaba Service Center http://www.hobbyservices.com/index.html
To Next Page
Loading...
