Function menu: See FNC.
F/S
P B H
FailSafe menu. Sets servo positions when interference is encountered or
signal is lost. Available only in PCM transmission mode. Also includes
Battery FailSafe (BFS) settings. Manual P. 42.
Gear trim mix: See ABE.
GL2: Model type, glider with 2 wing servos. See TYP.
GL4: Model type, glider with 4 wing servos. See TYP.
GL5: Model type, glider with 5 wing servos. See TYP.
GYR
O D I
Gyro sensitivity. Heli programming only. Used to create stick priority or
activate each rate of a dual rate gyro based on stick position. This
preprogrammed mix decreases the gain of the gyro directly proportional to
the amount of rudder stick given (or steps the gyro down from high to low
rate on dual rate gyros.) Manual P. 114.
Gyro sensitivity: See GYR.
Hel: Model type, rotary wing. See TYP.
Helicopter: Rotary wing model type. See TYP.
High Rate: See AFR.
HLD
O C L
Throttle hold. Heli programming only. This is a pre-programmed linear mix
with an offset. This mix makes the throttle servo no longer responsive to
throttle stick position, and moves the throttle servo to idle. This is used to
practice autorotations. NOTE: a helicopter model type pre-assigns a
condition specifically to be used for throttle hold or autorotation practice;
HOWEVER, it does not assign anything to this condition. Besides
activating throttle hold, you will need to create proper pitch curves to allow
blade inertia to increase during the drop, and sufficient pitch to bring the
helicopter back to a hover and land. Manual P. 110.
HOF
O C K
Hovering offset. Heli programming only. Adjusts the center point of the
pitch curves, including the hovering pitch curve, to fine-tune the hovering
point when it is not exactly center throttle stick position Manual P.109.
HOM: Home menu. Returns to home screen. Usually key R in menu screens.
Home: See HOM.
HOV: Hovering Pmix Type. See PMX. Also see P. 2-8.
Hover: To maintain a stationary position in which the model is not climbing, diving,
rolling or yawing.
Hovering offset: See HOF.
To Next Page
Loading...
