Hovering pitch: See PHV.
Hovering throttle: See THV.
Idle-up: Separate condition created to allow inverted and other types of flight with a
helicopter not easily achieved in the normal condition. Note: the 9Z is fully
programmable and nothing is pre-assigned into the idle-up conditions. Manual P. 101.
In-flight needle control: See FMC.
INH
Inhibit. Makes a feature inactive and unable to be used. When a function is
inhibited, it cannot be used even if the assigned switch is moved to the on
position. Setting a feature to INH turns off its functionality without losing
any settings. Only visible in specific features.
Inhibit: See INH.
INV
P D H O D
K
Inverted flight control.
Inverted: To fly a model upside-down.
Inverted flight control programming: See INV.
Limit Mode: ATV mode setting which limits the maximum servo travel. See ATV.
LIN: Linear, directly proportional. Linear Pmix Type. See PMX. Also see P. 2-8.
LINK: Mixing function which allows multiple mixes to work in conjunction. See PMX.
Lithium battery: See backup battery.
Low rate: See D/R.
LST List, to open a listing of available models, conditions, etc.
MAN Manual, not automatic. For example, see airbrake.
Master Mix Mode: Mix option which causes slave channel to operate based on master
channel’s ATV, not AFR or D/R settings. See PMX.
Mix: See Pmix.
Model name: See MNA.
Model selection: See MSL.
Model type: See TYP.
MNA
P C J
Model name, up to 8 characters long. Used to identify different model
memories. Note: base condition name can be set as the frequency used with
your FSS module to easily keep track of channel and still have 8 characters
to name your model. Manual P. 51.
To Next Page
Loading...
