FUTABA FP-3PB - BEFORE USING; Loading the transmitter battery; Changing the RF MODULE band; Receiver and servos connections

BEFORE USE
MiLoading the transmitter battery
(penlight battery x 7) WChanging the RF MODULE band
Eae Insert the batteries into the holder. TE Remove the module.
Va Wi
je Penlight battery
| (x7)
eee Remove the module by pulling it
in the arrow direction while
pressing the tabs at both sides.
@Dummy ` \ [Pay careful attention
to the polarity]
/ @
@ Battery holder LA + and — are L é ZB
displayed on the S A Š A g
AS “a
s holder.
Load the holder into the transmitter.
i JZ
Change the crystal.
i
pii
Z i
Battery cover * Use a receiver and transmitter crystal pair. Always
use matched Futaba clystals.
When using a Nicd battery pack-
@Use the NT-8LP.
@Use the Futaba charger as the charger.
@Charging time : 15 hours.
Push in the module until the tabs at
both sides lock with a “click” while
being careful that the pins are
not bent.
|k However, wheh the battery pack has not been used |
| for some time, it may be necessary to charge and | Ly
| discharge two or three times, before you gain a full , Ze S
| carge even if charged for the specified time (15 hours) | l (SSE Ge ive
| or longer. Wes Za è
B 27MHz Band | 29MHz Band | 40MHz Band | 72MHz Band | 75MHz Band
RF module | FP-TL-FM-27 | FP-TL-FM-29 | FP-TL-FM-40 | FP-TL-FM-72 | FP-TL-FM-75
Receiver FP-R113iP-27 | FP-R113iP-29 | FP-R113iP-40 | FP-R113iP-72 | FP-R113iP-75
Crystal set FM 27MHz Band|FM 29MHz Band|FM 40MHz Band FM 72MHz Band|FM 75MHz Band|
coe es
@Change the receiver crystal at the same time. Use a transmitter and
receiver crystal pair.
@When changing the frequency band, use the combination shown in the
table at the upper table.
M@iReceiver and servos connections
Set using an FET amp
4WS or twin
servo use \
E A Throttle
* Use the same : : S Ser
kind of servo as AS PY oe
the steering servo cS AÀ N SEE E
as the twin servo. A
(Option)
4WS or twin
| servo use
=
Throttle
servo
|
ors
ee
= AUX servo Nied b l | as the steering
i Icd battery servo as the
=> Battery/DSC cord pack (4.8V twin servo.
. he ee —' | or 6V) Saree oie ope eS Ee
Drive Nicd battery pack or penlight battery ( x 4)
m Steering servo
Switch