C
ONNECTING THE
GY701
TO YOUR
R
ECEIVER
Connect the supplied extensions to the GY701
connecter. Route the wires through the helicopter
mechanics and connect them to the appropriate
receiver channels. To determine the appropriate
receiver channels please check your transmitter’s
instruction manual. Using wire mounts, wiring
fixtures molded into the helicopter, or hook and
loop material, route the extensions to the receiver.
Ensure that the extensions leading to the receiver
cannot become entangled in rotating components
and make sure the extensions are not rubbing
against metal or carbon fiber which may damage
the wires.
Once the power system is installed into your heli-
copter please move onto the later section to learn
how to program the gyro.
18
To Next Page
Loading...
