S.BUS
B
ASIC
S
ETTING
62
This sets the function of the channel of the S.Bus
connection. It is required with the use of the S.Bus
compatible receiver. The wiring from receiver to
servos is made simple by using the S.Bus connec-
tion, only one main S.Bus wire is connected to
receiver and GY701 can complete the operation.
In addition, governor on/off switch function, F/
F mixing can be available through the S.Bus con-
nection. At the PWM connection, this function
is invalid. When not using an S.Bus channel, set
“INH” for the channel setting. The S.Bus channels
have linear 16ch, digital 2ch, 18ch total, but the
controllable channels are limited by the transmit-
ter channels.
(1) S.Bus connection setting: start display
Mode is changed by pushing mode + or – key.
Setting ranges common: 1
〜
16ch, DG1, DG2
Push MODE
+/– key
To Next Page
Loading...
