FUTABA GY701 - Page 33

G
YRO
B
ASIC
S
ETTING
33
(4) Limit setting [default: 100%, setting
range: 50
〜
150%]
Adjusting the maximum servo throw. Set the
amount to limit the rudder throw.
Move the rudder stick right (left) maximum. At
this point, increase or decrease the movement
by pushing the data+ or – key.
ｎ
WARNING
ｊ
Verify that the gyro compensates in the cor-
rect direction before flight. If the compensation
direction is incorrect the model will pirouette
uncontrollably, at a very high rate.
(5) Flight mode [default: F3C]
3ELECTIONOFTHEmIGHTSTYLE&#MODEISMORE
PRECISE RUDDERCONTROL THE$ MODEIS MORE
active rudder control, pirouette speed is faster
THAN&#MODE4HEMODEISCHANGEDBYPUSH-
ing the data+ or – key.
Pirouette rate at AFR100% to full stick:
F3C = 450 deg/sec
3D = 720 deg/sec
ｎ
WARNING
ｊ
When using the GY701 for the first time, or
when making changes in the throw of a servo,
always perform the limit setting operation.