FUTABA GY701 - Page 68

G
YRO
E
XPERT
S
ETTING
68
(10) Pirouette speed
default: 450 deg/sec (F3C), 720 deg/sec (3D)
ranges: 100
〜
999 deg/sec
This adjusts the pirouette speed of the rudder.
The default values are set 450 deg/sec on F3C
mode and 720 deg/sec on 3D mode when rudder
is 100 %. The bottom of the line shows the actual
pirouette speed of the rudder. When this value
exceeds 1200 deg/sec, the gyro is out of control,
the pirouette speed is very quick and this can be a
dangerous situation. Pushing the data+ or – key,
the value is changed.
(11) Gain change up delay
default: 12
ranges: 1
〜
50
This sets the delay of the gyro gain from low to
high, the value represents from idle up to hover-
ing. Increasing this value may stop tail hunting
if it is taking place. Pushing data+ or – key, the
value is changed.
(12) Gain change down delay
default: 3
ranges: 1
〜
50
This sets the delay of the gyro gain from high to
low, the value represents from hovering to idle up.