FUTABA GY701 - Page 70

G
YRO
E
XPERT
S
ETTING
70
Separate the pitch signal in the transmitter, and in-
put this signal to the GY701. To do that, make the
programmable mixing as pitch-> AUX, and input
AUX signal to the GY701.
This function is only available by the S.Bus con-
nection. Invalid is displayed in PWM connection.
Pushing data+ or – key, the mode is changed.
(16) F/F mixing rate
default: 0 %
range: -100%
〜
+100%
It adjusts the F/F mixing rate. It can adjust low or
high pitch rate individually from zero pitch point.
Pushing data+ or – key, the value is changed.
(17) F/F mixing acceleration gain
default: 0 %
range: 0
〜
200 %
It sets the F/F mixing acceleration gain. Pushing
data+ or – key, the value is changed.
(18) Pitch zero setting
default: 1520 uS
It sets the pitch zero point of GY701. Move the
pitch stick to the zero pitch, push data+ or – key.
The zero pitch signal is memorized in the GY701.
The display shows
！
mark at the setting point.