FUTABA SkyLeaf BP - Horizontal Stabilizer

12
Horizontal stabilizer
5
1.InstaltheElevators
1
1
1
2
Horizontalstabilizer
Elevator
1
1
3
4
5
6
7
＜ Horizontalstabilizer
Bottomside ＞
＜ Horizontalstabilizer
Bottomside ＞
Elevator
● Cutthefilm
accordingto
theprepared
hole.
19mm
● Spreadthehingeinsertpointsothat
thepaperhingeenters.
● PutfourpaperhingesinElevator.
ŬƑƖƈƕƗŃƋƄƏƉ
ŦŤŃƊƏƘƈ
● PourCAglueintoall
4hinges.
Makegluewicktotheinterior.
Ŷ,I WKH DLOHURQ LV RIIGXULQJIOLJKW LW ZLOO EH
XQFRQWUROODEOHDQGFUDVK
● PushtheElevatorintotheHorizontalstabilizer.
آ ťƈŃƆƄƕƈƉƘƏŃƑƒƗŃƗƒŃƐƌƖƗƄƎƈŃƗƋƈŃƉƕƒƑƗŃƖƌƇƈŃƄƑƇŃ
ƅƒƗƗƒƐŃƖƌƇƈő
● PourCAglueintothepaperhinge
insertedinthewing.
ųƘƖƋŃƌƑ
● MovetheElevatorafterdrying.Checkthatthe
aileronissecurelyattached.
ŰƒƙƈŃƌƗŃƖƈƙƈƕƄƏŃƗƌƐƈƖő
● AttachtheElevatortotheother
Horizontalstabilizerbythesamework.
űƒŃŦƏƈƄƕƄƑƆƈ
●CuttheControlHornforlengthadjustment.
Ruffupthebottomofthecontrolhornwith
sandpapertohelpthegluesticktothehorn.
● Adjustthelengthandpositionof
theControlHornwithreference
tothefigurebelowandthen
attachitwithCAglue.
ٴ ŦƒƑƗƕƒƏŃūƒƕƑŃƏƈƑƊƗƋŃƄƑƇŃƓƒƖƌƗƌƒƑ