FUTABA SkyLeaf BP - Page 15

15
Installation of Motor and Cowling : EP kit only
8
1
12
16
1
15
4
ūƒƒƎŐƄƑƇŐůƒƒƓŃŷƄƓƈ
ůŐƖƋƄƓƈƇŃƏƒƆƎƌƑƊŃƗƄƅ
ŷƒŃ ťƄƗ Ɨƈƕ Ɯ؞
ŵƈƆƈƌƙƈƕ
ŰƒƗƒƕŃƆƒƑƗƕƒƏƏƈƕ
1
● Installmotorwiringsothat
itislocatedatthebottom.
● InstallM4NylonNutandM4Washer
fromtheinsideofFuselage.
● AttachtheMotorcontrollerusingtheHook-and-
LoopTapeatthelowerpartofcowlingofthenose.
3
● Cowlingcomeswith4L-shapedlockingtabs.Insert
thislockingtabintotheholeoffuselageandlower
itdownwardtolockcowling.
● AttachCowlingtothefuselage.
● Holeforinserting
locktab(4places)
● Insertitbackwards,thenlock
itbythrustingdownwards.
This page is an explanation of the case of electric motor.
(It is unnecessary in the case of engine.)
● Drillfourholeswitha4mmdrillintheposition
oftheMotormountfigure.Determinethehole
positionaccordingtothemotoryouuse.
● Thereisamarkoftheholepositionaccordingto
FutabaFMA-5055KV525Motor.
● FixtheMotorwithfourM4NylonNut,M4Washer
andM4 × 12Hexagonbolt.