FUTABA T26SZ - Page 123

123
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŧƄƗƄŃƕƈƖƈƗ
Model memory setting data reset. (by item)
This function is designed to allow you to reset
selected portions or all of the settings saved in
the active model memory. You may individually
choose to reset the following sets of data:
Trim (All condition):
Reset the digital trim setting.
*All the conditions, or the condition currently being
displayed (the entire group for group setting), can
be selected.
*The trim step amount and trim rate are not reset.
Trim (Current and Group condition):
Reset the digital trim setting.
*Current condition, group condition, can be
selected.
ŧƄƗƄŃƕƈƖƈƗƗƌƑƊŃƐƈƗƋƒƇ
1. Tap to the item you want to reset and tap the
screen.
*The trim step amount and trim rate are not reset.
Model menu setting:
Resets all the functions in the Model menu except
condition select.
All model setting:
Resets all Linkage and Model menu functions
except for system type, model select, model type,
function name, and telemetry setting.
Function Name:
A function name is reset.
Telemetry:
Reset the telemetry setting.
$FRQ¿UPDWLRQPHVVDJHDSSHDUV
[Trim (All condition)]: Resets only the Trim (all
conditions)
[Trim(Current and Group condition)]: Resets only
the data of Trim (condition in use and all the
conditions set to group mode)
[Model menu setting]: Resets all the functions in
the model menu, except the condition selection
functions.
[All model setting]: Resets all the functions in
the linkage menu and model menu except
the frequency, model select, and model type
functions.
[Function name]: Resets only the function name
functions.
[Telemetry]: Resets only the teremetry functions.
2. Execute reset by tapping the "Yes".
●
Select [Data reset] at the linkage menu and call the
setup screen shown below.
CAUTION
ThrottleReverse
■ Onlythethrottlechannel(CH3)initialsettingis
REV(reverse).ThoroughlychecktheHiandLow
directionsoftheengineormotorusedandbecareful
thattheydonotsuddenlyrunatfullspeed.Even
afterdatareset,CH3isreversed
.
CAUTION
NeverengagetheDataresetfunction
whiletheengineisstartingorthe
motordrivewiringisconnected.
■ Sudden,abruptspinningofpropellersorrotorsis
extremelydangerous.
●
Return to Linkage menu