FUTABA T26SZ - Page 131

131
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Foresequencerscanbeset.
Thesequencerhasthreesettingstochoosefrom.
● Basic
1.Geardownafterasettimeafterthedooropens.
2.Thedoorclosesafterasettimeaftergearingup.
● Thesequencerautomaticallyusesprogram
mixingwhenconfigured.Usetheunused
programmixingnumber.Thisconfirmation
screenwillappear,sotap“Yes”toenablethe
settings.
● CycledoorandBoostusetwosystemsof
programmixing.
● Cycle
1.Geardownafterasettimeafterthedooropens.
2.Doorclosesafterasettimeaftergeardown.
3.Gearupafterasettimeafterthedooropens.
4.Thedoorclosesafterthesettimeaftergearingup.
● Boost
1.Geardownafterasettimeafterthedooropens.
2.Doorclosesafterasettimeaftergeardown.
3.Closethedoorstronglyforthesettime.
4.Gearupafterasettimeafterthedooropens.
5.Thedoorclosesafterthesettimeaftergearingup.
6.Closethedoorstronglyforthesettime.
Onceset,thisdisplaywillappear.
Dooropens Doorcloses
Geardown
ŶƈƔƘƈƑƆƈƕ
Setting the operating timing of the landing gear
and door (gear cover). [All model types]
ŏ7RXFKWKH>6HTXHQFHU@EXWWRQLQWKH0RGHO0HQXWRFDOO
the setup screen shown below.
ŏ5HWXUQWR0RGHO0HQX