FUTABA T26SZ - Page 158

158
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ELEVATOR
(RUDDER2)
RUDDER
(ELEVATOR2)
ŹŐŷƄƌƏ
[Corresponding model type]: Airplane/glider, Tail type V-tail
This function lets you adjust for left and right rudder
angle changes at elevator and rudder operation of a
V-tail airplane.
V-tail is when 2 servos are used together to control
rudder movement as elevators. In addition to each
rudder side moving up and down together, each side
moves in opposite directions when moving as elevators.
On a V-tail, this is also known as a ruddervator, as they
can serve the same purpose.
(Rudderfunction)
Leftandrighttraveladjustmentat
CH1andCH2rudderoperation
(Elevatorfunction)
Upanddowntraveladjustmentat
CH1andCH2elevatoroperation
ŏ6HOHFW>97DLO@DWWKHPRGHOPHQXDQGFDOOWKH
setup screen shown below.
ŏ7UDYHODGMXVWPHQW
Tap to the item you want to adjust.
$GMXVWWKHUDWHXVLQJWKHʈʈʈʆʆʆ
buttons.
*If the mixing direction is reversed by the linkage,
adjustments can be made by changing the mixing rate
polarity (+ or -).
,IDODUJHYDOXHRIWUDYHOLVVSHFL¿HGZKHQWKHVWLFNVDUH
moved at the same time, the controls may bind or run out
of travel. Decrease the travel until no binding occurs.
Conditiongroup/
singlemodeselection
(Gr./Sngl)
ŏ5HWXUQWR0RGHOPHQX