FUTABA T26SZ - Page 16

16
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ųƒƚƈƕŃŲũũ
ųƒƚƈƕŃŲű
ThrottleStickLow
PowerSwitch
PowerSwitch
LongPush
Tap“Yes”
Push
1.
Turn on the transmitter power switch.
2.
Turn on the receiver or speed control power switch.
Always be sure the motor/engine is stopped.
1.
Turn off the receiver or speed control power switch.
2.
Then turn off the transmitter power switch.
ON
OFF
OFF
ON
ŷƘƕƑƌƑƊŃƒƑŃƗƋƈŃƓƒƚƈƕŃƖƚƌƗƆƋƈƖ
If the power switches are turned off in the opposite order the model may unexpectedly run out of control and cause
a very dangerous situation.
ŷƘƕƑƌƑƊŃƒȭŃƗƋƈŃƓƒƚƈƕŃƖƚƌƗƆƋƈƖ
ūƒƚŃƗƒŃƗƘƕƑŃƗƕƄƑƖƐƌƗƗƈƕŃƓƒƚƈƕŃŲűŒŲũũŃ
:KHQWXUQLQJRQWKHSRZHUWKH76=WUDQVPLWWHUZLOOEHJLQHPLWWLQJ5)DXWRPDWLFDOO\DIWHULWFRQ¿UPV
the surrounding RF conditions. The status of the transmitter is displayed by LED at the upper part of the
front of a T26SZ.
*If THR stick is high, a WARNING screen will appear. Another warning will appear if a power
supply is attached. (In Multicopter mode, the THR position alarm will not appear.)
ŬƉŃƗƋƈŃŅŷūŵŃƓƒƖƌƗƌƒƑŅŃƄƏƄƕƐŃƇƌƖƓƏƄƜƖ
*If the throttle stick is in the high position when the
power is turned ON
Warningalarm
Tapheretostopthealarm
andRFsignal.Onlypanel
screenoperationisactive,the
transmitterwillnotlinktoany
receiver.
When the alarm activates, lower the throttle stick
before turning the receiver power ON.
*If the power is turned ON when the idle-up, air brake,
etc., switches are ON, the above warning will display.
Ensure the relevant switches are turned OFF.
*The setting to turn off immediately is the “H/W
setting” screen in the system menu.
2QFH\RXWXUQR൵WKHSRZHUWKHSRZHUR൵SURFHVV
will start, and the power will not turn back on even if
you turn it on again during the process. If you want
to turn it on again, wait for a while.