FUTABA T26SZ - Page 229

229
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
This section describes the functions often used at the function setup screen. Refer to it when setting
each function.
*URXSVLQJOHPRGHVZLWFKLQJ*U6LQJO
:KHQVHWWLQJPXOWLSOHÀLJKWFRQGLWLRQVOLQNLQJ
the setting contents with all conditions (group
mode) or setting independently (single mode)
can be selected. The mode can be changed at the
[Gr] item on each setup screen.
[Group/single mode switching]
ŏ*URXSPRGH*U
The same setting contents are set to all the
ÁLJKWFRQGLWLRQV
ŏ6LQJOHPRGH6LQJO
Set this mode when the setting contents
are not linked with other conditions.
&RQGLWLRQGHOD\VHWWLQJ
Unnecessary fuselage motion generated when
there are sudden changes in the servo position
and variations in the operating time between
channels can be suppressed by using the
condition delay function of the condition select
function [Condition select].
When the delay function is set at the switching
destination condition, a delay corresponding to
that amount is applied and the related functions
change smoothly.
[Setting method]
1. Switch to the condition you want to set
and tap the delay[ 0 (value)].
2. Set the delay using the
" ▼▼ "" ▼ "" ▲
"
ʆʆEXWWRQV
Initial value: 0
 $GMXVWPHQWUDQJHaPD[LPXPGHOD\
(When the value is tapped, the delay is reset to the initial
value.)
ŲƓƈƕƄƗƌƒƑƖŃƕƈƏƄƗƈƇŃƗƒŃƳƌƊƋƗŃƆƒƑƇƌƗƌƒƑƖ
ŲƓƈƕƄƗƌƒƑƖŃƙƄƏƘƈŃƖƈƗƗƌƑƊ
Tapping the value setting buttons on each screen will cause value input
buttons to appear at the top of the panel.
Valueinputbuttonsdisplay
atthetopofthepanel
Pressingandholding
avaluewillreturnit
toitsdefaultsetting.
Smallchange
invalue
Largechange
invalue
Largechange
invalue
ŦƒƐƐƒƑŃƒƓƈƕƄƗƌƒƑƖŃƘƖƈƇŃƌƑŃƉƘƑƆƗƌƒƑŃƖƈƗƘƓŃƖƆƕƈƈƑ
Tap
Tap
Tap