FUTABA T26SZ - Page 238

238
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
(Switch selection screen example)
źƋƈƑŃƖƚƌƗƆƋŃƌƖŃƖƈƏƈƆƗƈƇ
Switch ON/OFF setting is possible at each position.
1. When the ON/OFF "Set" position switch is tapped
after the switch was selected, the screen shown
below appears.
*When the button of each position is tapped, it
toggles between ON and OFF.
2. Tap the button and set to the ON position.
3. Close the screen by tapping [Hardware select].
źƋƈƑŃƖƗƌƆƎŏŃƗƕƌƐŃƏƈƙƈƕŏŃƒƕŃŹŵŃƌƖŃ
ƖƈƏƈƆƗƈƇő
When a stick, trim lever, or VR is used as a switch,
the following 4 modes can be selected.
Next page
Tapthechosen
switch.
NormalorAlternate:Alternateswitching
modeisavailabledependingonmixing
function.
Systemmenu→H/WsettingSwitchquickassignfunctionisOFF