FUTABA T26SZ - Page 62

62
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
WARNING
NeverlaunchtheModelSelectionfunction
whiletheengineisstartingorthemotordrive
wiringisconnected.
■ Carelessspinningofpropellersorrotorsisextremely
dangerous.
WARNING
Carefullycheckthattheaircrafttobeusedand
themodelselectedmatchup.
■ Usingamodelwhichdoesnotmatchtheaircraftruns
theriskoftheaircraftflyingoutofcontrolandcrashing.
Performacarefuloperationscheckpriortoflight.
ŰƒƇƈƏŃƆƒƓƜ
1. The model data chosen at current model can be
copied. The current model name, tap.
2. Tap the "Copy" button and tap the destination
button and select the copy storage destination.
(Internal or SD card)
3. When [Internal]or [SD card] is tapped, copying is
executed.
*If there is no model with the same name in the copy
destination, the name of the copied model is saved. If there
is a model of the same name, a number is added at the end
of the model name and the model is copied. You can change
the name later.
*Indication date : When the model data is copied, the creation
date for the current model is recorded.
*T26SZ can use model data of T16IZ, T16IZ SUPER, T16SZ,
T18SZ, FX-36, FX-32. Other transmitter model data is not
available. However, if the model data conversion function
(described at the end of this manual) is used, part of the
model data of T14SG, FX-22, T12K can be used.
Currentmodel(green)is
chosen(blue).
addnewcopiedmodel
źƋƈƑŃƘƖƌƑƊŃƐƒƇƈƏŃƇƄƗƄŃƒƉŃŷŔřŬŽŏŃ
ŷŔřŬŽŃŶŸųŨŵŏŃŷŔśŶŽŏŃŷŔřŶŽŏŃũŻŐŖřŏŃ
ũŻŐŖŕ
1.The microSD card in which the model data of
another transmitter is saved is displayed on the
model select screen.
2. Copy the model data of another transmitter to
T26SZ. The data will be converted for T26SZ.
3. Select the converted model data.
*The model data converted for T26SZ cannot be used in
another transmitter.
T16IZ,T16IZSUPER →
T18SZ,T16SZ,FX-36 →
FX-32 →