EasyManua.ls Logo

FUTABA T26SZ - Page 81

FUTABA T26SZ
248 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
81
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Targettime
Time
Alarm:
LasttensecondsLasttwentyseconds
Oneshort
beep
Twoshort
beeps
Also
beep
Continuecounting
withdisplayinga
minus(-)sign.
ŷƌƐƈƕ
Timer setting
The Timer function may be set for
any desired time, i.e. engine run time,
specified times for competitions, etc.
Two independent timers are provided
for your use. The timers are stored
independently with each model, meaning
that when you switch between model
setups, the timer associated with the new
model is brought up automatically.
The timers may be set to start and stop
from the motion of any switch or stick.
You may set the ON and OFF directions
freely. Each timer has a capacity of up to
59 minutes 59 seconds.
Each timer may be set for count-down or count up operation
with a target time.
If a target time is set and the timer reaches the set time, a
buzzer sound for each count is generated.
Atimeronthehomescreenstartsandstopsitscountdown
directlyfromtherewhentapped.Tappingandholdingthe
displaywillresetthetimer.
[Start/Stop] → Homescreen
Timer1 Timer2
ABuzzerorSpeech
canbechosen
ŸƓŃƗƌƐƈƕŒŧƒƚƑŃƗƌƐƈƕŃƖƈƏƈƆƗƌƒƑ
1. Tap the mode button and select the type of timer.
2. Timer time setting.
Tap the Mode minutes or seconds button.
Value input buttons appear on the screen.
Use these buttons to set the timer time.
ŶƗƄƕƗŒŶƗƒƓŒŵƈƖƈƗŃƖƚƌƗƆƋŃƖƈƗƗƌƑƊ
1. Tap the Start/Stop/Reset SW "--" button to call the
<Switch> screen, and then select the switch and its
ON direction.
(For a detailed description of the selection
method, see [Switch selection method] at
the back of this manual. The timer switches
can be set for each condition.)
[Inhibit] →[Type1-4] If
itcarriesoutlikethis,a
vibrationfunctionwill
work.
●
Select [Timer] at the linkage menu and call the setup
screen shown below.
Return to Linkage
menu
OFF:TurningthepowerOFFandswitchingmodelswillresetthetimer.
ON:Previoustimerisputintomemoryandwillrestartfromwhereitstopped.
Elapsed:Minute-by-minute
alarmstartingfrom00:00
Remainder:Minute-by-
minutealarmcountingdown
fromadesignatedtime
Constant:Thealarm
doesnotstop
Onetime:Stopthe
alarmatonce

Related product manuals