FUTABA T26SZ - Page 86

86
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
RegisteredsensorSlotNumber
Thisiswhatdisplayswhennosensor
isregisteredinaslot.Tappingtheslot
andselecting
"-----------"willerasewhateverwas
registeredthere,freeinguptheslot.
Taptheslottodisplay
sensorswhichcanbeused
forthestartslot.Tapto
registerthesensor.
SensorID:Multipleusageofsensorsof
thesametyperequiresanIDbeinput.
Tappingthiswillallowformanualinput,
butseethenextpageabouthowto
performauto-registrationviasensor
registration.
ŶƈƑƖƒƕ
Various telemetry sensors setting
This screen registers the telemetry sensors used
with the transmitter. When only one of a certain
type of sensor is used, this setting is unnecessary
and the sensor can be used by simply connecting it
to the S.BUS2 port of the transmitter.
When using 2 or more of the same kind of sensor,
they must be registered here.
>:KDWLVDVORW"@
6HUYRVDUHFODVVLILHGE\&+EXWVHQVRUVDUH
FODVVL¿HGLQXQLWVFDOOHG³VORW´7KHUHDUHVORWVIURP
1RWR1R
$OWLWXGHVHQVRUV*36VHQVRUVDQGRWKHUGDWDVHQVRU
XQLWVPD\XVHPXOWLSOHVORWV
:KHQXVLQJDVHQVRUZKLFKXVHVWZRRUPRUHVORWV
WKHUHTXLUHGQXPEHURIVORWVLVDXWRPDWLFDOO\
DVVLJQHGE\VHWWLQJXSDVWDUWVORW
:KHQRUPRUHRIWKHVDPHNLQGRIVHQVRUDUHXVHG
WKHVHQVRUVWKHPVHOYHVPXVWDOORFDWHXQXVHGVORWV
DQGPHPRUL]HWKDWVORW
ŏ7DSWKH>6HQVRU@EXWWRQLQWKH/LQNDJHPHQXWR
call the setup screen shown below.