FUTABA T6K - Page 8

Addition of the MATRIX type of flight modes (Multicopter type only)
5 flight modes can be set to PRIORITY type. 9 flight modes can be set to MATRIX type.
◆ PRIORITY TYPE e.g. Setting 5 ight modes in MultiCopter Model Type
◆ MATRIX TYPE e.g. Setting up the transmitter to operate the tilt of a camera using switches A and C.
The mode change rate of
the multicopter control
box (CH6 use)
[TLEMETRY] Page 2
[Current setting screen] [Voltage setting screen] [Capacity setting screen]
Camera tilt
control rate
Camera tilt
control rate
●Vibrator ON/OFF ●Vibrator ON/OFF ●Vibrator ON/OFF
Activating CH6 and CH7
allows the functions to
control the camera angle.
CH6 sets the option to
change modes.
[PRIORITY] is select by
3 pages.
[MATRIX] is select by
3 pages.
Flight mode change
switch
SWA SWC Flight Mode
Normal
F-Mode 1
F-Mode 2
F-Mode 3
F-Mode 4
SWA SWC
CAMERA Servo Rate
100 100
100 50
100 0
50 100
50 50
CH6 CH7
50 0
0 100
0 50
0 0
Addition of the current sensor and voltage sensor function
Compatible with the SBS-01C (current sensor) and SBS-01V (voltage sensor).
●"DN" indicates the
alarm will start when
the current reaches
below your set value.
●"DN" indicates the
alarm will start when
the voltage reaches
below your set value.
●"DN" indicates the
alarm will start when
the capacity reaches
below your set value.
●"UP" indicates the alarm will start
when the current reaches above
your set value.
●"UP" indicates the alarm will start
when the capacity reaches above
your set value.
●Current ●Voltage
●Consumption
capacity
● Switch selection ● Switch selection ● Switch selection ●Speech function. ●Speech function. ●Speech function.
●The maximum and the minimum
when powering ON are shown.
●The maximum and the minimum
when powering ON are shown.
●The maximum and the minimum
when powering ON are shown.
● Maximum and minimum date
reset by pressing the Jog key
for 1
second.
● Maximum and minimum date
reset by pressing the Jog key
for 1
second.
● Maximum and minimum date
reset by pressing the Jog key
for 1
second.
FUTABA CORPORATION Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba 299-4395, Japan
©FUTABA CORPORATION 2016, 12 (1)
The SBS-01C can monitor and display
the in-flight current, voltage, and current
consumption of the drive battery.
The SBS-01V can monitor and display
the in-flight voltage of the drive battery.
*Solder welding is required for instruction.