Future Design LIMIT L91 User Manual

49
Logic Low:
Logic High:
Functions:
-10V minimum, 0.8V maximum.
2V minimum, 10V maximum.
Remote reset, remote lockout.
Logic Low:
Logic
High:
Functions:
Output 1 / Output 2Output 1 / Output 2
Relay Rating:
Pulsed Voltage:
2A/240 VAC, life cycles 200,000 for resistive load.
Source Voltage 5V, current limiting resistance
66 ohms.
Relay Rating:
Pulsed
Voltage:
Triac (SSR) Output
1/240 VAC
20A for 1 cycle
50 mA rms
3mArms
1.5 V rms
1000 Mohms min. at 500 VDC
2500 VAC for 1 minute
Rating:
Inrush Current:
Min. Load Current:
Max. Off-state Leakage:
Max. On-state Voltage:
Insulation Resistance:
Dielectric Strength:
Triac (SSR) Output
Rating:
Inrush
Current:
Min.
Load Current:
Max.
Off-state Leakage:
Max.
On-state Voltage:
Insulation
Resistance:
Dielectric
Strength:
DC Voltage Supply Characteristics ( Installed at Output 2 )DC Voltage Supply Characteristics ( Installed at Output 2 )
Type
Tolerance
Max. Output
Current
Max. Output
Current
Ripple
Voltage
Ripple
Voltage
Isolation
Barrier
Isolation
Barrier
20 V20 V +/-0.5 V+/-0.5 V 25 mA25 mA
0.2 Vp-p0.2 Vp-p
500 VAC500 VAC
500 VAC500 VAC
500 VAC500 VAC
12 V12 V
+/-0.3 V+/-0.3 V 40 mA40 mA
0.1 Vp-p0.1 Vp-p
5V5 V +/-0.15 V+/-0.15 V 80 mA80 mA
0.05 Vp-p0.05 Vp-p
Event InputEvent Input
Analog Retransmission
Functions: Process Variable
Output Signal: 4-20 mA, 0-20 mA, 0 - 5V, 1 - 5V, 0 - 10V
Resolution : 15 bits
Accuracy : +/-0.05 % of span +/-0.0025 %/ C
Load Resistance : 0 - 500 ohms ( for current output )
10 K ohms minimum ( for voltage output )
Regulation: 0.01 % for full load change
Settling Time: 0.1 sec. (stable to 99.9 % )
Breakdown Volts: 1000 VAC min.
Linearity Error : +/-0.005 % of span
Temp Effect: +/-0.0025 % of span / C
Saturation Low : 0 mA ( or 0V )
Saturation High : 22.2 mA ( or 5.55V, 11.1V min. )
Output Range :0-22.2mA(0-20mA or 4-20mA)
0-5.55V ( 0 - 5V, 1 - 5V )
0-11.1V(0-10V)

Future Design LIMIT L91 Specifications

General

Brand	Future Design
Model	LIMIT L91
Category	Controller
Language	English