Before cleaning, checking or repairing the
appliance, make sure that the engine has been
switched off and has cooled down. Disconnect
the spark plug to prevent accidental starting. For
all maintenance work
Wear safety gloves.
Non-compliance with regular
maintenance work on the device can result in
personal injury and damage to property.
Always keep your chainsaw in
perfect condition.
MAINTENANCE AFTER EACH USE / BEFORE
STORAGE
1. Air filter
Loosen the knob and remove the air filter cover.
Remove and adhere the filter element. Brush off
sawdust. If the filter is clogged, take it apart in
half and wash it out in petrol. When using
compressed air, blow through from the inside.
Remove the socket up to a
audible click to reassemble the filter halves.
2. Oil supply opening
Remove the chain stay and check the oil supply
opening for blockage.
(1) Oil supply opening
3. chain stay
When the chain stay is dismounted, remove the
accumulated sawdust from the guide groove and
the oil supply opening. Lubricate the front
sprocket through the lubrication hole at the front
of the chain stay.
(1) Oil supply opening
(2) Lubrication opening
(3) Gear wheel
To Next Page
Loading...