Original User Manual FX-4MS131_rev03
25
PROTECTIVE SHIELD-KNIFE SHARPENING.
1. Remove the cutting blade (E) from the protective shield (F).
2. Clamp the knife in a vice. Sharpen the knife with a flat-file.
Please make sure that you keep the angle of the cutting edge.
Move the blade only in one direction.
STORAGE OF A MACHINE
WARNING: If these steps are not taken, plaque will form in the carburettor
and cause difficult starting or permanent damage due to storage.
1. Perform all general maintenance recommended in the maintenance section of
your user manual.
2. Clean the exterior of the machine, drive axle, protective shield, and nylon cutting head.
3. Drain fuel from the fuel tank.
4. After fuel is drained, start the machine.
5. Let the device idle until the machine stops by itself. That cleans the carburetor of fuel.
6. Let the machine cool down (about 5 minutes).
7. Use a spark plug wrench, remove the spark plug.
8. Pour one teaspoon of clean 2-cycle oil into the combustion chamber. Pull the starter cord
slowly several times to coat the internal components. Replace the spark plug.
9. Store the machine in a cool, dry place away from any ignition source such as
an oil burner, water heater, etc.
TRANSPORT PROTECTION
Make sure that the machine is well visible during transport to avoid fuel loss, damage, or injury.
Use transport protection for metal sheets during transport and storage.
To Next Page
Loading...
