Original User Manual FX-4MS131_rev03
9
Keep hands and feet free of the nylon cutting head or metal blade during the
operation.
Do not use the machine if you are tired, sick, or under the influence of medication,
drugs, or alcohol.
Use an undamaged nylon cutting-head. If you hit a stone or any other obstacle, stop
the machine and check the nylon cutting head. Never use a defective or unbalanced
nylon cutting head.
Before starting, after failure or impact, be sure to check the device and make sure it is
in good condition.
Attention! Local regulations may limit the use of the machine.
Always keep the device with the cutting tool in good condition.
Note, improper maintenance, use of non-compliant spare parts or removal or
modification of safety devices can cause damage to the device and severe injury to
the person working with it.
Secure the device properly during transportation to prevent loss of fuel, damage to the
device, and injury.
For machines with a clutch, regularly check that the cutting attachment stops
rotating when the engine is idling.
Before each use, check the machine for loose fasteners, fuel leaks, damaged parts,
etc. Replace damaged parts before use.
It is necessary to take sufficient breaks and change the working position regularly.
4. Instructions for accessories
Do not store the machine in an enclosed area where fuel vapours can reach an
open fire from water heaters, stoves, etc. Store the device in a well-ventilated area
only.
Make sure that your product is only equipped with original accessories. These parts
are available from your dealer. The use of any other accessories or attachments
may cause injury to the user and damage to the machine.
Clean the machine thoroughly, mostly the fuel tank and air filter. All fuel must be
removed after using the
device.
IMPORTANT: When filling fuel, make sure that the machine is off and cooled down.
Never refuel when the device is running or hot. If gasoline is spilt, wipe it up before
starting the engine.
Keep at least 15m distance to other persons during the work.
If you, as a spectator, approach a user of the machine, carefully attract his attention
and confirm that the user stops the engine. Please do not startle or distract the user.
Otherwise, you could cause an unsafe situation.
To Next Page
Loading...
Need help?
General
