Original User Manual FUXTEC FX-FSR152_de_fr_rev05
9
3. Intended use and general safety instructions
This device may only be used for mowing or trimming grass, weeds and
undergrowth. Never use it for other purposes, as this may cause serious
injuries!
Correct safety instructions must be observed. DO NOT EXPOSE YOURSELF OR OTHERS
TO DANGER. Follow these general safety instructions:
● Always wear safety glasses for eye protection. Long hair must be tied back. Do
not wear loose clothing or jewellery that can get caught in moving parts of the
device. Safe, robust, non-slip safety shoes must always be worn. It is
recommended that legs and feet are fully protected to guard against flying
objects during operation
● Check the entire device for loose parts (nuts, bolts, screws, etc.). Maintain or
replace them, if necessary, before using the device. Do not use accessories with
this drive head other than those recommended by the manufacturer. Otherwise,
severe injury to the user or bystanders and damage to the device may result
● Keep the handles free of oil and fuel
● Always use correctly mounted handles when cutting
● Do not smoke when mixing the fuel or filling the tank
● Do not mix fuel in an enclosed space or near open fires. Ensure adequate
ventilation / aeration
● Mix and store the fuel mixture in a marked container approved for such use
according to local regulations
● Never remove the fuel tank cap while the device is running
● Do not operate the device in closed rooms or buildings. Exhaust gases contain
dangerous carbon monoxide
● Do not use the device if it is damaged. Never remove safety equipment from the
device. Otherwise, the operator or the spectators may be seriously injured, and
the device may be damaged
● Check the area to be cut and remove any residue that may be entangled in the
nylon cutting head. Also, remove any objects that the device may throw around
during cutting
● Never leave the device unattended
● Do not stretch out far forward. Always maintain a secure stand and balance.
● Children must not have access to the device. Spectators should stand at least 15
meters away from the working area.
● Keep hands and feet away from the nylon cutting head during operation
To Next Page
Loading...
Need help?
General
