FUEL
The engines are lubricated with oil that has a
special formula for use with air-cooled 2-stroke
petrol engines. Please use an oil with
antioxidant additive specifically designed for
use with 2-stroke air-cooled petrol engines. For
this purpose, we recommend specially adapted
FUXTEC 2-stroke oil "Made in Germany" for
a long durability of the engine (available
directly from the manufacturer).
Carefully fill the two-stroke mixture into the
tank (p.5 No.9). Make sure that no petrol
mixture runs outside the tank (danger of
ignition)
RECOMMENDED MIXING RATIO
FUEL/OIL 40:1
It must be ensured that gasoline with a
minimum octane number of 95RON is used.
Petrol in litres 1 2 3 4 5
2-stroke oil in ml 25 50 75 100 125
Keep open fire away from areas where fuel is
used or stored. Mix and store fuel only in
approved canisters.
NOTE
Most damage is caused directly or indirectly by
the fuel used. Never use 4-stroke oil for mixing.
FUXTEC SAW CHAIN OIL
We recommend the use of FUXTEC saw-chain
oil "Made in Germany" for long durability
(Available at FUXTEC direct).
Do not use used oil or reconditioned engine oil
as this could cause the oil pump to malfunction.
Carefully fill the chain lubricating oil into the oil
tank (p.5 No.10). Make sure that no chain
lubricating oil runs outside the tank (danger of
ignition)
To Next Page
Loading...
Need help?
General
