FUXTEC FX-MT152 User Manual

Original User Manual FUXTEC FX-MT152/-MT152E/-MT252_rev16
18
Mounting the all-round handle/attachments
Attaching the handle
The handle must be fitted before use.
Follow the illustrations below for correct installation.
Mounting the wrap-around handle
 There are four holes for mounting the wrap-around handle
 Take the wrap-around handle.
 Align the position of the holes.
 Insert the screws into the holes and tighten them until you feel resistance.
 Tighten the screws well.
Mounting the attachments
1). Place the drive axle against the main shaft so that
the hole of the axle is aligned with the locking pin of the
connecting piece.
2). Actuate the locking pin and insert the drive axle into
the main shaft. Release the locking pin and ensure that
the locking pin engages in the hole.
3). Turn the wing screw clockwise to secure the
connection.

FUXTEC FX-MT152 Specifications

General

Brand	FUXTEC
Model	FX-MT152
Category	Cutter
Language	English