5. OPERATION
Starting the engine
z Primer Button
Incoldcondition,it’snecessarytopushtheprimerbuttonontheairfilterbeforepullingthestarterhandle.
Primer only for cool engine use
You also should put more fuel to mix air for easy start. When you push the primer button, it will pump the
fuel direct from carburetor to burning house.
NOTICE: In cold condition it may be necessary to repeat priming steps for starting the engine.
z Pull back on the brake lever and hold it against the handle.
z With the starter handle in its support, take the starter handle with your right hand and pull slowly as far
as to have a resistance, and then pull energetically on the starter handle with starter rope through the
support. (If the cold start is not sufficient enough, repeat this operation 2 or 3 times)
To Next Page
Loading...
