appendices
p. 293
Appendix. Standardized Warning Statements for AC/DC Systems
The following statements are industry standard warnings, provided to warn the user of situations
which have the potential for bodily injury. Should you have questions or experience difficulty,
contact G-Technology’s Technical Support department for assistance. Only certified technicians
should attempt to install or configure components.
Read this appendix in its entirety before installing or configuring components in the chassis.
Warning Denition
You are in a situation that could cause bodily injury. Before you work on any equipment, be aware of
the hazards involved with electrical circuitry and be familiar with standard practices for preventing
accidents.
Installation Instructions
Read the installation instructions before connecting the system to the power source.
Circuit Breaker
This product relies on the building’s installation for short-circuit (over current) protection. Ensure
that the protective device is rated not greater than: 60VDC, 20 A.
Power Disconnection Warning
The system must be disconnected from all sources of power and the power cord removed from
the power supply module(s) before accessing the chassis interior to install or remove system
components.
Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Restricted Area
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security. (This
warning does not apply to workstations).
Battery Handling
There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only
with the same or equivalent type recommended by the manufacturer. Dispose of used batteries
according to the manufacturer’s instructions
To Next Page
Loading...