Gabarron ECOHHR30 - Setting the Weekly Program - Continued; Setting the Weekly Program - Copying Days

Setting the Weekly Program -
continued
If you wish to change the temperature level from Noon
(Economy) to Sun(Comfort) for this 30 minute segment
00:30 to 01:00 then Press the sun (comfort) button. The
display will now flash between the time interval 00:30 and
Sun(Comfort).
Now Press the Plus button to move to the next 30
minute segment. The display will now flash between the
time interval 00:30 and this temperature level
Repeat the above steps, selecting either the Sun(Comfort)
temperature or Noon(Economy) temperature and pressing
the Plus button to move to the next 30 minute segment.
You repeat this until you go through all the 30 minute
segments and the display shows dAY1 again.
At this point you can either Press the Plus button and
repeat the above for day 2 and the other days or copy day1
to day2, day2 to day3, day3 to day4, and so on.
5
User Operating Instructions
Repeat above steps and go through all 24 hours
until dAY1 (or programmed day) is displayed again.
Setting the Weekly Program -
Copying Days
To copy dAY1 to dAY2.
(while on the day you want to copy)
Press and Hold the Plus button until CP12(copy day 1
to day 2) is displayed and then release. After a short time
the display will show dAY1 again.
Press and Release the button to move to day 2, dAY2
is now displayed.
To copy dAY2 to dAY3.
Press and Hold the Plus button until CP23(copy day 2
to day 3) is displayed and then release. After a short time
the display will show dAY2 again.
Press and Release the button to move to day 3, dAY3
is now displayed.
Repeat as above and go through copying each day.
Once you have gone through all the days the
display will show the set temperature as you have
programmed.