INSTALLATION INSTRUCTIONS
1.- WARNING Please read these instructions before installing or using this appliance for the first time.
• The warranty of the heater will not cover any damage caused by
non observance of any of these instructions.
• This guide must be kept and given to any new owner.
• Please check that the voltage in the rating label fits the pow
er supply.
• Any reinstallation should be carried out by trained personnel.
• The use of these heaters is forbidden in any area where there is a presence of gase
s, explosives or inflammable objects.
• DO NOT USE THIS HEATER TO DRY CLOTHES.
• The surfaces of this heater can be hot, so young children should not be left unsupervised in the vicinity of the heate
r.
• Neither the connecting cable nor any other object must come into contact
with the hot unit.
• Do not cover this heater at any time.
• The air outlet at the top of the thermal radiator and the air inlet at the bott
om are provided to ensure the most efficient operation of the
appliance. They also protect the heater from overheating; therefore, it is essential that at no time are they covered.
• This heater should be switched off at the isolating switch befo
re any repair work is carried out.
• The thermal radiator should not be installed just be
low an electrical socket.
• The appliance must be installed in such a way that it is impossible for an
yone using a bath or shower, to touch the controls.
• The installation must be carried out in accordance wi
th the current electrical regulations.
• The heater is fitted with a flexible cable size 3 x 1.00 mm2 for electrical connection. It ma
y be used to connect the heater to the fixed wiring of
the premised through a suitable connection box positioned adjacent to the heater.
• The supply circuit to the heater must incorporate a double pole isolating switch having a contact separation of at least
3 mm.
• If the flexible power cable for this unit is damaged, it may only
be replaced by a repair workshop recognised by the manufacturer, as special
tools are necessary.
• This appliance must be earthed.
• All models are supplied with an electrical interrupt cut-out. This will switch off the heater if, for any reason, it overheats. Should t
he cut-out
operate, turn the heater off and remove the cause for the overheating. The cut-out will be reset automatically.
• The presence of air particles of smoke, dust and ot
her pollutants could, in time, discolour the walls and surfaces around the heater.
• This heater is filled with a precise quantity of special oil. Repairs requiring the
opening of the oil container are only to be made by the
manufacturer or his service agent who should be contacted if there is an oil leakage.
• Regulations concerning the disposal of oil when scr
apping the appliance have to be followed.
Modelo
RF4P RF6P RF8P RF10P RF12P RF14P RF4E RF6E RF8E RF10E RF12E RF14E
TYPE Manual - Thermostat only Digital - 24hr / 7 Day Timer & Thermostat
MODULES 4 6 8 10 12 14 4 6 8 10 12 14
W (cm) 41.5 57.5 73.5 89.5 105.5 121.50 41.5 57.5 73.5 89.5 105.5 121.5
D (cm) 10 (plus 2.5 cm separated from the wall)
H (cm) 58
WEIGHT (kg) 9.5 13.5 17.5 21.5 25.5 29.5 9.5 13.5 17.5 21.5 25.5 29.5
INPUT
500W 750W 1000W 1250W 1500W 2000W 500W 750W 1000W 1250W 1500W 2000W
VOLTAGE 220-240V~
2.- INSTRUCTIONS ON INSTALLATION
- Open the carton at the indicated side. The screws are in the accessories bag. Tu
rn the carton upside down to allow the heater to stand. Check
that it is the correct model and that it is in good condition.
- To obtain optimum performances it is necessary to maintain a mini
mum clearance of 15 cm between the radiator and any inflammable material
as furniture, curtains etc. See figure .
shel
To Next Page
Loading...
