Gaggenau DF211700 - 14 Basic Settings; Overview of the Basic Settings

en-us Basic settings
22
Basic settings
14 Basic settings
Basic settings
You can configure your appliance to meet your needs.
14.1 Overview of the basic settings
The basic settings depend on the features of your appliance.
Basic setting Selection Description
Time setting 00:00 - 24:00 Set the current time.
The setting depends on the time format selected.
Time format 12 h
24 h
1
Set the time format.
Time display In hours
Time
1
Set the time display for the end of the wash cycle.
"Finish in" shows the remaining time the wash cycle still
has to run, e.g. 3h25min.
"Finish at" shows the time when the wash cycle will end,
e.g. 3:20pm.
Sprache/Language See selection on the appli-
ance.
Select the menu language.
Water hardness 0 - 62
0 - 8
1
Set the water hardness.
→ "Overview of water hardness settings", Page14
Rinse aid disp. 0 - 6
5
1
Set or switch off the amount of rinse aid to be dispensed.
→ "Setting the amount of rinse aid", Page16
Sensor setting Standard
1
Sensitive
Very sensitive
Set the water sensor for identifying soiling.
→ "Sensors", Page5
Extra Dry on
off
1
Switch "Extra Dry" on or off for each operation.
The temperature is increased during the final rinse for a
better drying result. This may increase the run time slightly.
Please take care with delicate dishware.
Eco forecast on
off
1
Switch EcoCheck on or off.
When selecting the wash cycle, the average water and en-
ergy consumption is briefly shown on the display.
Emotion Light™ off
On via main switch
1
On when opening door
Switch the interior lighting of the appliance on or off.
When the appliance door is opened, the interior lighting
switches off automatically after 10 minutes.
Infolight® on
1
off
Switch "Infolight®" on or off.
While the wash cycle is running, a spot of light is projected
onto the floor below the appliance door. This light will not
be visible if the appliance is installed at eye level with the
cabinet front fitted flush. If the appliance door is not com-
pletely closed, the spot of light will flash. The wash cycle
has ended when the spot of light is no longer visible on the
floor.
Start program Auto 130-150°F
1
Prog. last selected
Set a default program for when the appliance is switched
on.
Tone volume Scale with multiple levels. Set the signal volume at the end of a wash cycle.
Level 0 switches the signal tones off.
Button volume Scale with multiple levels Set the button volume during operation.
Level 0 switches the button tones off.
WLAN on
off
Switch the wireless network connection on or off.
The basic setting "WLAN" is not available until you have
connected the appliance with the HomeConnect™ app.
→ "HomeConnect™ ", Page23
Remote Start off
Manual
Permanent
Activate or deactivate .
The basic setting is not available until you have connected
the appliance with the HomeConnect™ app.
→ "HomeConnect™ ", Page23
1
Factory setting (may vary according to model)