GALAXIS SHOWTECHNIK PYROTEC G-Flame - Page 4

4
Page
22.1. The LED 'Operation'
32
22.2. The LED 'Flame'
32
22.3. The LED 'Charging'
33
22.4. The LED 'Low Battery'
33
22.5. Functional check of the LEDs
33
23. The warning LED 'Attention armed'
33
24.
The menu
34
24.1. Standard menu items
34
24.1.1. The menu item 'Language'
34
24.1.2. The menu item 'Accumulator capacity'
34
24.1.3. The menu item 'Accumulator power'
34
24.1.4. The menu item 'Input'
35
24.1.5. The menu item '45° Tilt Switch'
35
24
.1.6. The menu item 'Flame monitoring'
36
24.1.7.
The menu item 'Acoustic Signals'
36
24.1.8.
The menu item 'LCD Backlight'
36
24.1.9. The menu item 'Warning LED'
37
24.1.10.
The menu item 'Battery measurement'
37
24.2. Menu items if DMX512 has been s
elected as an input
39
24.2.1. The menu item 'Flame Channel'
39
24.2.2. The menu item 'Safety Channel'
39
24.2.3. The menu item 'Power Supply for Wi
-
DMX'
40
24.3. Menu items if the Advanced wireless module has been
installed and 'Cable (RS485 of PFC)' or 'Wireless (PFC or PFS)' has
been selected as control method 40
24.3.1.
The menu item 'RF Channel' (i.e. frequency selection)
40
24.3.2.
The menu item 'Interfering Signal'
41
24.3.3.
The menu item 'Last Range Test Result'
41
24.
3.4.
The menu item 'Device ID number'
42
24.3.5.
The menu item 'Determine Hazard Zone'
42
24.3.6. The menu item 'Terminal Programming'
43
24.3.6.1. Overview regarding the parameters of the Terminal
programming 43
24.3.6.2. The selectio
n menu of the Terminal programming
43
24.3.6.3. The menu item 'Terminal programming: Keep up & Exit'
44
24.3.6.4. The menu item 'Terminal programming: Edit'
44
24.3.6.5. The menu item 'Terminal programming: Delete'
45
25.
Switching off
46
26. The emer
gency off input
46
27.
Command 'Firing mode off'
46
28. Receiving mode or respectively ready to fire mode
46
28.1. Displayed information during receiving mode or respectively
ready to fire mode, that appears in all operation modes 47
28.1.
1. Information which control method has been selected
47
28.1.2. Tilt switch on/off and its status
47
28.1.3. Flame monitoring on/off
48