Galletti S.p.A. - Via L.Romagnoli 12/a
40010 Bentivoglio (BO) Italy
Made in Italy
CATEGORY category
Serial number
Code
Date of production
Cooling capacity (W)
Heating capacity (W)
Power supply
Power input (kW)
Weight (kg)
Max power input (kW)
Max running amperage (A)
HP power input (kW)
Refrigerant
Max refrigerant pressure
Max refrigerant temperature (°C)
The unit data are reported on the rating label in this page.
(FAC-SIMILE)
THE LABEL SHOWS THE FOLLOWING DATA:
Ū Series and size of the unit
Ū Date of manufacture
Ū Main technical data
Ū Manufacturer
Ū The label is applied on the unit, usually on the enclos-
ing panels
IMPORTANT: NEVER REMOVE THE LABEL
Ū Unit serial number
Ū The serial number permits to identify the technical
characteristics and the components installed
Ū Without this datum it will be impossible to identify the
unit correctly
SAFETY SYMBOLS
Carefully read this manual.
Warning
Use personal protective equipment (gloves for refrig-
erant, protective goggles)
Warning: the unit of this range are charged with A2L
uid (slightly ammable) R454B
Warning:
Electrical and electronic products may not be mixed with
unsorted household waste. Do NOT try to dismantle the
system yourself: the dismant¬ling of the system, treat-
ment of the refrigerant, of oil and of other parts must be
done by an authorized installer and must comply with ap-
plicable legislation. Units must be tre¬ated at a specialized
treatment facility for reuse,recycling and recovery. By en-
suring this product is disposed of correctly, you will help
to prevent potential negative consequences for the envi-
ronment and human health. For more information, contact
your installer or local authority.
It's strictly forbidden to smok near the unit
GENERAL CAUTIONARY NOTES
Ū Do not put into service until you have read and under-
stood the information in the following manual. This
document, together with all other documents provid-
ed, should be retained for the entire life of the unit.
Contact the manufacturer for any further information.
Ū Keep this manual intact in a safe place for the all life of
the unit.
Ū Carefully read all the information contained in this
manual, paying special attention to sections marked
"Important" and "Warning"; failure to comply with the
instructions provided could result in injury to persons
or damage to the equipment.
Ū Should a fault occur, consult this manual and if neces-
sary contact the nearest Galletti S.p.A. service centre.
Ū All installation and maintenance operations must be
carried out by qualied personnel, unless otherwise
indicated in this manual.
Ū The rst start up must be carried out exclusively by
qualied personnel and authorized by Galletti S.p.A.
(see warranty sheet attached).
Ū Before performing any work on the unit, disconnect it
from the power supply.
Ū Failure to comply with the rules provided in this man-
ual will result in the immediate invalidation of the war-
ranty.
Ū Galletti S.p.A. shall not accept any liability for injury
or damage resultingcfrom improper use of the equip-
ment or failure to comply with the directions provided
in this manual and on the unit it self.
Ū It's mandatory to install lters heat exchangers protec-
tion will immediately invalidate the warranty.
To Next Page
Loading...
