EN-7
To operate your Game Ready System, you need:
•
A Control Unit filled with ice and water
•
A Game Ready supplied power supply
•
A Connector Hose
•
A Wrap (a Heat Exchanger and Sleeve)
Notes:
•
The Wrap is comprised of an inner Heat Exchanger and an outer Sleeve. The combination
of Sleeve and Heat Exchanger is referred to throughout this manual as a “Wrap.”
•
The Game Ready Control Unit should be placed on a stable surface (such as the floor or a
table) during use.
•
Please note that using the System in an environment with a high ambient temperature
may affect its ability to provide adequate cooling, or may limit the ice life.
•
If you will be using the System with a Game Ready supplied battery pack please consult
the instructions for use that accompanied that battery pack for usage details.
Warning:
Position the Control Unit to minimize the risk of tripping over the Control Unit, Connector
Hose or power cord.
Warning:
Your Game Ready Control Unit should be plugged into a grounded electrical outlet prior to
operation.
Precautions:
•
Failure to properly follow the set-up instructions may result in inadequate therapy.
•
Unplug the Control Unit from the electrical outlet prior to filling the Control Unit with ice
and water.
USING YOUR GAME READY SYSTEM
STEP 1:
:
Push the door release button to open the ice box door.
STEP 2:
Fill the ice box completely with ice, and at least ½ full with clean water.
1
2
To Next Page
Loading...
