Gamko E3 - Installation; Installing the Appliance

26
E3
Operating principle
Installing the appliance
Chapter2-Installation
Never install the
refrigerator next to a
heat source!
Arefrigeratorworksbyextractingheatfromthespacetoberefrigeratedandtoreleasethisinthesurrounding
area.Formaximumaircirculationitisrecommendedtoallowat least 10mm space around the refrigerator.
Be very careful never to obstruct the air inlets and outlets.
Theadvisedmaximalheightoftheloadismarkedwiththeloadlinesontheinsideofthecabinet.
Placetheapplianceonaatsurface.
1 Place the appliance at his position.
2 Make sure the appliance is standing level using a spirit level.
3 The appliance must be placed with feet to provide adequate air circulation around the cabinet. This for
an optimal operation of the appliance and to dispose of possible leakages of R600a. Also, the legs are
used for appliance adjustment and leveling.
4 Adjustthestands(1)with6mmAllenwrenchintheopenings(2)untiltheproductislevel
5 Tightenthescrews(3)ofthefootpieces(1),atthebottom,withawrench,whentheadjustingdeviceis
not accessible from the inside.
6 Plugtheopenings(2)ontheinsidewiththesuppliedcaps
7 Ifthelegsarenotassembled,theholesinthebottommustbelledwiththeinsulatingcapsprovidedto
prevent condensation and loss of energy. This is to prevent condensation and loss of energy.