Gamko E3 - Using the Appliance; Prior to Use; Thermostat Operation

• Cleanthecabinetpriortouse.Forfurtherdetailsseechapter4:maintenance.
• Leavethebottlecoolertostandforatleast2hoursbeforeswitchingonthecabinet.
• Plugintoagroundedpowersocket.
Prior to use
EMERGENCY STOP
ISOLATE FROM THE POWER SUPPLY
Chapter3-Usingtheappliance
Thermostat
Light on/o Up/down button
settings
Manual defrost
Set button
Using the thermostat
Icon Description
Press to display the setpoint value and the actual setpoint value.
Toswitchthelightonando.
Hold for 3 seconds to reset the saved energy reduction pattern.
Press for more than 3 seconds to start defrosting.
(Up)Scrollthroughtheparametercodesinsettingsoritincreasesthedisplayvalue.
(Down)Scrollthroughsettingsinparametercodesoritlowersthedisplayvalue.
ECOandOn/Opresstoactivateordeactivatetheenergy-savingmodefunction.Hold
for3secondstoswitchthedeviceonando.
Eco
On/o
30
E3