Gamko E3 - Troubleshooting

Troubleshooting
Attention
The cabinet does not start
Temperature is too high, in spite of recent adjustment of thermostat
Temperature is too low, in spite of recent adjustment of thermostat
Water leak
Thermostat notications
Always remove the plug from the socket when carrying out repairs.
• Checktheplug.
• Restorethepowersupplybyreplacingafaultfuseorbyusingtheon/oswitch.
• Contactyourlocalserviceorganisation.
• Check/restorepowersupply.
• Removecontentswhichmayobstructventilation.
• Cleanmagneticseal,orgasket,replaceifnecessary.Removecontentswhichmayobstructventilation
• Defrostevaporator.
• Thermostatorcompressorisdefective.
• Fan(evaporatororcondenser)isdefective.
• Contactyourlocalserviceorganisation.
• Thermostatisdefective.
• Contactyourlocalserviceorganisation.
• Defrostregularly–ifnecessaryextramanualdefrostcycle.
• Checkiftheapplianceislevel.Ifnecessary,leveltheappliance.
• Contactyourlocalserviceorganisation.
• ThecodeP1appearsinthedisplay.
• InformtheGamkoservicedepartmentoryoursupplier.
34
E3