Need help?Do you have a question about the Gantner Q.bloxx A109 and is the answer not in the manual?
General| Number of Channels | 8 |
|---|---|
| Protection Class | IP20 |
| Measurement Range | ±10 V, ±20 mA |
| Connection Type | Screw terminals |
| Input Type | Voltage |
| Accuracy | 0.05% |
| Supply Voltage | 10 to 30 V DC |
| Operating Temperature | -40 to +85 °C |
| Interfaces | Ethernet |
| Isolation | Channel to channel and channel to ground isolation |
| Resolution | 24-bit |
Defines the scope of applications for Q.series products in industrial and experimental test engineering.
Specifies that only competent persons should perform installation, operation, and maintenance.
Highlights hazards associated with high voltages (up to 1200V) on specific modules and safety measures.
Explains the meaning of DANGER, WARNING, CAUTION, and NOTICE symbols for hazard communication.
Details connection types and pin assignments for specific Q.bloxx modules (A101-D107) and sensors.
Instructions on establishing connections and finding modules using the test.commander software.
Details setting sensor parameters, selecting sensor types, and configuring scaling for analog inputs.
Explains how to configure digital inputs and outputs, including status indicators and process outputs.
Describes setting up analog outputs, including voltage/current selection and scaling.
Covers configuring Test Controller settings like module interface, host interface, and synchronization.
Provides instructions for updating firmware on Test Controllers and modules to the latest version.
Guides on scaling voltage signals and strain gauges, including using calibration data and calculators.
To Next Page