Need help?Do you have a question about the Ganz ZC-YX270P and is the answer not in the manual?
General| Model | ZC-YX270P |
|---|---|
| Category | Security Camera |
| Brand | Ganz |
| Image Sensor | 1/2.8" Progressive Scan CMOS |
| IR Distance | Up to 30m |
| Wide Dynamic Range | Digital WDR |
| Ingress Protection | IP67 |
| Varifocal | Yes |
| Lens Type | Varifocal |
| Day/Night | IR cut filter with auto switch |
| Video Compression | H.265/H.264 |
| Network Interface | RJ45 10/100M Ethernet |
| Power Supply | PoE (802.3af) |
| Operating Conditions | -30 °C ~ 60 °C |
| Mount Type | Wall/Ceiling |
| Power | 12 VDC ± 25%, PoE (802.3af) |
Adjusts focus after lens mounting by rotating wheel.
Screw to loosen for flange back adjustment; must be retightened.
Switches camera output for auto-iris lens based on type (DC or VIDEO).
Used to navigate and adjust settings within the OSD menu.
Adjusts video iris lens brightness and VR position via OSD menu.
Facilitates focus adjustment using edge enhancement and zoom features.
Connects camera to TV monitor via coaxial cable.
Accepts 24V AC or 12V DC power supply.
Power cable for 230V AC models.
Pin assignments for connecting auto-iris lens cables.
Fixes picture mode to B/W or selects OSD profiles.
Enables remote OSD operation via RS485 communication.
Manages termination resistance for RS485 communication.
Output for NVT Receiver via UTP cable.
Selects video output between UTP and BNC connectors.
To Next Page
