Gap Diagnostic IIDTool - Activation Using the Integrated (II) Interface

To Next Page

To Previous Page

IIDTool

5.2.2 Activation using the Integrated (II) Interface

Steps to activate the IIDTool using the Intergrated (II) Interface.

1- Turn ignition ON without starting the engine (turning the key to “ON, II” or press the “start en-

gine” button without simultaneously pressing the brake pedal).

2- Connect the IIDTool on the OBDII connector

3- Wait 30 seconds until the “ IIDTool Ready ” message is displayed on the instrument pack screen.

This delay is caused by the scan process which detects which ECUs are present.

4- Lunch the Integrated Interface by pressing on the

button.

5- Reach the activation code by browsing through the menus as follows : Menu -

IIDToolCong

Unlock Code

6- Note the 10 character activation code.

Note : It is possible to scroll the code from left to right if required with the and buttons.

7- Send us the activation code by e-mail at

support@GAP-Diagnostic.com

8- Following receipt of the unlock code as a reply to your e-mail (during operating hours

only), return to the vehicle, repeat steps 1 to 5

9- Enter the Unlock Code using the corresponding commands

10- Once the unlock code is entered correctly, the IIDTool will backup the suspension calibration

andCarCongurationFile(CCF).Aconrmationofexecutionwillbedisplayed.

The user has now access to advanced programming functions and data backup.

Transfer of ownership guide,

Other manuals for Gap Diagnostic IIDTool