GAPOSA Emitto Smart Line - Erasing Transmitter; Reset Motor Memory

PROGRAMMING
ERASING TRANSMITTER
RESET MOTOR MEMORY
Push simultaneously the SYNC button and STOP
of the transmitter until the motor makes a brief
movement in both directions.
Only the transmitter used for this procedure has
been deleted from motor memory.
OPTION 1 - Using an already programmed transmitter
Press and hold both the SYNC and STOP buttons
until the motor makes first a brief jog and, after
a while, a second, long jog. Memory is now
empty.
x2
OPTION 2 - Without an already programmed transmitter
1
Switch the motor power supply OFF.
Then switch it ON.
OFF
ON
ON
2
Within 8 seconds, using any Gaposa
transmitter, press and hold both the
SYNC and STOP buttons until the
motor makes a long jog.
Memory is now empty.