GAPOSA Emitto Smart Line - Intermediate Position; Recalling Intermediate Position; Erasing Intermediate Position

INTERMEDIATE POSITION SETUP
(Just for motors with electronic limit switch)
RECALLING THE INTERMEDIATE POSITION
ERASING THE INTERMEDIATE POSITION
Press simultaneously, both the UP and
DOWN buttons until the motor makes a brief
movement in both directions.
[QCTZ01/04] Keep the STOP button pressed
at least for at least 3 seconds.
[QCTZ02/03] Press the PRESET button.
3”
QCTZ01
QCTZ02
QCTZ04
QCTZ03
1
Stop the shutter/awning in the desired
intermediate position.
2
Press simultaneously the UP and DOWN
buttons until the motor makes a brief
movement in both directions.
The intermediate position has been setup.
INTERMEDIATE
POSITION