INSTALLATION PART 1: MOUNTING BRACKET
Step 3: Install The Mounting Bracket, cont.
Tighten the screws with a ½" wrench until the
bracket is snug against the ceiling (Figure 1.5).
As you turn the wrench, you should feel
resistance. If the lag screw turns freely, your
pilot hole is not in the ceiling joist and must be
repositioned on a secure portion of the joist.
Align the MyLifter unit with the mounting
bracket, and insert the two quick-release pins
through the MyLifter unit and mounting bracket
(Figure 1.6).
Fig 1.5
Fig 1.6
15
To Next Page
Loading...
