i.
ii.
iii.
iv.
Go to your phone's settings and select Bluetooth.
Find "Gard Pro" and select forget this device.
Restart your phone.
Launch the GloryFit app and follow the connect instructions.
While setting up the Gard Pro Ultra, you will be asked to provide access
to use your contacts. You must allow this.
If you want to turn off the Gard Pro Ultra you need to hold down the power
button for ± 3 seconds. Then the Gard Pro will ask you to turn off the device.
Press the green check mark.
Make sure the Gard Pro is charged and press and hold the power button for 3
seconds. The Gard Pro Ultra will vibrate to indicate it is turned on.
c. Synchronized contacts:
b. Disable the Gard Pro Ultra:
a. Turning on the Gard Pro Ultra:
d. If the connection between the Gard Pro Ultra and your phone is
broken, follow these steps:
ULTRA
PAGE 03
3. INSTRUCTIONS FOR QUICK USE
i.
ii.
iii.
iv.
Open the GloryFit app.
Open ''Device.''
Then press ''Bluetooth Call.''
Follow the instructions at ''Sync Contacts''
Note: that you can add a maximum of 100 contacts to your list.
You could possibly choose to also completely uninstall the GloryFit app to
redo entire installation process.
To Next Page
Loading...