GARDASOFT TR-HT2 Series - 10 Ethernet Address; IP Address

TR-HT2xx LED Controller - User Manual
10 Ethernet address
You may need to ask your network administrator for advice about setting
up the Ethernet connection.
The application note APP923 – Troubleshooting Ethernet problems is
available from www.gardasoft.com/Downloads.
The Ethernet set up of the TR-HT is not affected by cold-booting the
controller.
10.1 IPaddress
The TR-HT needs an Internet Protocol (IP) address to communicate over
Ethernet. There are two ways to get an IP address; either programmed
into the unit or using DHCP.
For DHCP mode, the TR-HT acquires its IP address, subnet mask, and
gateway address from the DHCP server. Otherwise the TR-HT has a fixed
IP address, subnet mask, and gateway address.
DHCP mode or the IP address can be set or read using the
GardasoftMaint program available from www.gardasoft.com/Downloads.
The GardasoftMaint window is shown below:
— 43 —