Gardena C 1060 Profi - Connecting the water computer to the tap

90
GB
The Water Computer is fitted with a sleeve nut
L
for taps with
G1” (33.3 mm) thread. The adaptor supplied
K
allows the
Water Computer to be connected to taps with a G 3/4” thread
(26.5 mm).
Connect Water Computer to water tap with G 1” (33.3 mm)
thread:
1. Screw sleeve nut
L
of the Water Computer on to the tap
thread by hand (do not use pliers).
2. Screw tap connector
M
on to the Water Computer.
Connect Water Computer to tap with G 3/4”(26.5 mm) thread:
1. Screw adaptor
K
on to the tap manually (do not use pliers).
2. Screw sleeve nut
L
of the Water Computer on to the adaptor
thread
K
by hand (do not use pliers).
3. Screw tap connector
M
on to the Water Computer.
Before you start entering the watering data in the computer
we recommend that you write the data on one of the watering
plans in the appendix to maintain more of an overview.
Connect Water Computer:
G
I
z
P
L
M
K